▼ Menu

KT66

Sensibly equivalent to:
6L6G CV1075 EL37 PP60 VT75
See also:
Osram Advert, December 1947 - Osram Advert, December 1952 - Osram KT66 Advert - Some Important British Valves - Brimar 25P1 Amplifier - The Williamson Amplifier - Osram KT2, KT76, KT33C, KT66, KT61, KT66, PX4 & PX25 Advert - Osram KT2, KT63, KT61, KT66, PX4, U50, KT76, KT33C, KT71, U76 & U31 Advert - Osram Valve Range Advert - KT66 and KT88 Advert - Push-Pull Phase Splitter
    
Extras ▼

 

The KT66 is a very well known audio output beam tetrode valve. Our exhibit is a post-WWII device, probably dating from the 1960s. From the 1970s KT66s lacked the internal carbon dust coating of the glass bulb. In the 1950s the production used black base caps and pre-WWII had the classic envelope shape.
In 1952 the KT66 was advertised as the finest audio tube in the world.
The KT66 was essentially a 6L6 redesigned with a larger cathode and a shorter, fatter anode. The KT66 had less rapid acceleration, longer electron paths, and almost no kink. It was ace for audio hi-fi but the electrons took longer to reach the anode and were more open to influence from magnetic, etc, fields on the way. Moreover, under HF conditions the electron stream was not perfectly in phase with the grid signal and this resulted in a loss of output power if used for RF applications.
The figures given are for single ended use, but a pair run in ultra linear AB2 push pull will deliver 50 Watts with 2% distortion.
The Marconi label, just one brand of the M-OV company of GEC.
It is not uncommon to find these valves used in parallel push pull. Here each single valve of the push pull pair is replaced with two valves connected in parallel. A 100 W amplifier results.
The shape of the envelope is a mixture of the classic shape and the wide tube. Due to the metallisation on the inner of the envelope the electrode structure is obscured.
The EL37 is not a direct equivalent and neither is the 6L6. The El37 has a high value of gm of 11.0 mA/V and the 6L6 has a value 5.2 mA/V
The classic envelope is 50 mm in diameter and, excluding the IO base pins, is 118 mm tall.
References: Data-sheet, 1004, 1005 & 1040. Type KT66 was first introduced in 1937. See also 1937 adverts.

 

Pin Connections
IO
1
2
3
4
5
6
7
8
m
h
a
g2
g1
nc
h
k,bp

 

Absolute Maximum Operating Conditions
Beam Tetrode
Vh
Ah
Va
Vs
Vg
mAa
mAs
ra
gm
Pout
D
6.3
1.27
250
250
-15
85
6.3
22.5k
6.3
7.25
9%
Thanks to Frank Philipse for supplying the above PDF datasheet.
Updated December23, 2020.
Return to Main Index